Elkay EGUH312010L Installation Guide download pdf

ATTENTION INSTALLER:

1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL

EXPERIENCED INSTALLER.

2) WARNING: THE ENCLOSED CUTOUT TEMPLATE WILL CREATE A COUNTERTOP OPENING THAT WILL

EXPOSE APPROXIMATELY 1/2" OF SINK RIM LEDGE. IT IS RECOMMENDED THAT YOU DISCUSS THIS

WITH YOUR CUSTOMER AND AGREE THAT THIS FINISHED APPEARANCE IS THE DESIRED EFFECT.

ELKAY IS NOT RESPONSIBLE FOR IMPROPER SINK OR COUNTERTOP INSTALLATIONS. DUE TO THE

AESTHETIC QUALITIES OF THE CONVERGING BOWL RADII, THE TEMPLATE FURNISHED WITH EACH

SINK PROVIDES THE ONLY OPENING RECOMMENDED FOR INSTALLATION OF ELKAY UNDERMOUNT

SINKS. SEE ILLUSTRATION ABOVE.

3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP

(I.E. GRANITE/CORIAN

/SILESTONE

4) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION.

5) METAL EDGES MAY BE SHARP – USE CAUTION WHEN HANDLING.

6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.

7) INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION.

. Undermount Stainless Steel Sinks

with 1/2" Reveal Countertop Installation

Undermount and Drop-In

Installation Instructions

COUNTERTOP

MOUNTING

BRACKET

FASTENER

(NOT FURNISHED)

1-1/8"

SINK

SILICONE CAULK

(NOT FURNISHED)

COUNTERTOP RECESSED

APPROX. 1/2"

INSTALLING SINK

1. Position template on countertop. Locate the template

front to rear, so that sink will not interfere with the

cabinet.

2. Trace a line around the template. Cut along the inside

of this line to provide opening. This size opening will

provide approximately a 1/2" Reveal. (Please see item

#2 under Attention Installer.)

3. Locate and drill the mounting holes (following the

countertop manufacturer’s instructions) as shown

above. Holes should allow even spacing of mounting

brackets around the sink. Type of fasteners to be as

recommended by countertop supplier.

INSTALLING SINK

4. Fasten mounting brackets to countertop loosely.

5. Using a good quality silicone caulk, apply a bead

evenly all around the top of the sink flanges.

6. Position and align sink over the countertop opening.

Press silicone onto countertop.

7. Tighten fasteners until mounting brackets are snug

against sink.

8. Check alignment of sink to countertop opening.

9. Tighten down fasteners evenly. Be careful not to over-

tighten. Remove excess silicone.

1 2 3 4

Summary of Contents

Page 1 - Installation Instructions

ATTENTION INSTALLER:1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONALEXPERIENCED INSTALLER.2) WARNING: THE ENCLOSED CUTO

Page 2 - . Self Rim Sinks

STEP ONEPlace sink upside down on countertop surface.Place sink in exact position for installationand pencil completely around sink to create a sinkou

Page 3

Suggestions for the Care and Cleaningof your Stainless Steel SinkSoft Satin FinishElkay's soft satin finish is a non-directional swirl finish.Reg

Page 4 - Warranty